A Touch of Realism Tutorial:
Now sometimes in the map making process you need to change the color of something or neutralize a certain color or tone down a color. Here are a few tricks to help you accomplish whatever goal you may have
For example purposes I will use a brick wall
I have also selected the color blue for it is a more difficult color to do this with and thus will make the tutorial more of a one size fits all.
Begin by selecting a image and a color(s) to use
Select a low opacity and the fill tool
Now along the way there are a few common problems you will run into.
Now sometimes parts of the image are naturally darker and this will mix with your color causing it to appear darker then the area around it.
Unto your fill and tone down the opacity. Then try filling it twice. Never fill more then three times or you will lose the realism affect.
This is a trial and error part to see which opacity works best depending on the image.
If the fill appears dotted and does not look realistic. First undo the fill. Then do the same fill with a lower opacity. It should look the same but lighter.
Then zoom very far in and select no more then two
areas where the fill is most dotted. Return to your old opacity and fill in these parts.
Sometimes a bit dotty can look good to simulate wear:
Continue this then sit back and enjoy your beautiful new image, with a Touch of Realism